relopanti.blogg.se

So now you go back to main model and the std 3d view and cut which to me goes blank and then supposedly go tyhe copy and paste to same place in atrium roof opt 2 so u can attach the the three smaller walls to the new atrium roof

how do i change that cut out from the hip roof So you delete roof in option 2 and create a atrium roof using the extrude okīut you still have the dormer cut out. You copy the roof and the three smaller walls to atrium roof 1 but not roof twoīecause option 2 is where you are going to make changes. Then you make two options for atrium roof Ty for your time and patience i hit a brick wall with the atrium So, momentarily they were overlapping existing walls, but not after I put them in a DO.īy the way the little movie really helped i could watch over and over and reenact the commands I copied and pasted the 3 wall aligned to the same place, and immediately put them into the Atrium Option 2 Design Option. when you paste the three walls to atrium option 2 arent you putting the 3 walls on top of existing 3 walls?

It's called a "Dedicated View".ĭedicate Views to a Design Option | Revit Products 2016 | Autodesk Knowledge Networkĭo i go back to the main model and select roof but when i did that to smaller hip roof wasnt in atrium roof option 2ģ. how do i change roof to change to the new atrium roof?Īre you asking how to create a View which shows a particular Deign Option? Go to the View's Visibility and Graphic Overrides Design Option Tab and set the Design Option you want the View to show (not "Automatic"). how can i now make a atrium opt 1 with the largw windows and atrium roofĪre you asking how to make the Atrium Roof Option 2 the Primary? If so, go into the Design Options, select the Atrium Design Option 2 and press "Make Primary".Ģ.